Archive for March 2012

Choosing Led Light Armband Manufacturers

A led light armband can be used on arms, legs and ankles among others to improve general visibility especially in conditions where there is low light. In short these armbands are used for security and protection in areas where visibility is very poor. As such, it is important to note that there are different manufacturers who are involved in designing and manufacturing of these armbands. While this is the case, it is important to ensure that you have made the right choice of manufacturer to end up with a perfect armband. There are some strategies that you can use in order to choose the right manufacturer. Read on to learn some of these strategies.
led

  • Price

When choosing a led light armband manufacturer, it is important to consider the price being offered on the products. It is important to take ample time to do some price comparison so that you can choose the manufacturer who will provide you with the best deal.
led

  • Reputation

It is important to choose a manufacturer who is highly reputed when it comes to making the armbands. This is important because if anything goes wrong along the way, you can easily make your claim. However, settling for a manufacturer who is not well known can cause you to fall in the hands of fraudsters and you will lose at the end of it all. It is therefore important to do some research on the different manufacturers first in terms of reputation to get the best out of the best.

Designing Your Own Led Lamp

Today, you have an opportunity of lighting your room using a high intensity led. This is because these lights tend to use less energy and this has in turn made energy conscious consumers to identify with them. In addition to this, they come with various advantages compared to other types of lights. While this is the case, you can simply design your own led lamp that you can use for lighting as well.The process of designing this lamp is moderately easy but it requires you to be dedicated and determined in order to make it worthwhile for you.
led
When designing a led lamp, it is important to have a dead battery on hand. Remove its top using a knife while at the same time snipping all its solder joints that are connected to its terminal cap. Once done, pull out the cap carefully before proceeding. You are supposed to mark and at the same time trim the led legs in order to get your connections right. Use the correct procedure of bending the legs so that you can have them close to each other. The legs that are on the outer should be left untrimmed.
led
The next thing that you will do is to solder the LEDs together ensuring they are lined up side by side. One done, you can mount the LEDs to the top of the battery ensuring that the legs are in perfect position. Attach the old battery to a fresh one and snap the terminal of the led cluster cap that easily fits on the fresh battery. Then you are good to go in turning your lamp on.